Cảm biến từ BN 120L-10Z/V 2,0M

Schmersal 101210880

Thông số kỹ thuật cảm biến công tắc từ tính Schmersal BN 120L-10Z/V 2,0M

đại lý schmersal | đại lý BN 120L-10Z/V 2,0M

nhà phân phối schmersal | nhà phân phối BN 120L-10Z/V 2,0M

Dữ liệu đặt hàng

Dữ liệu chung

Nguyên tắc làm việc	Magnetic drive
Housing construction form	Cylinder, thread
Vật liệu thân	Glass-fibre, reinforced thermoplastic
Trọng lượng thô	56 g

Dữ liệu chung – Features

Dữ liệu cơ học

Actuating panels	front side
Yếu tố kích hoạt	Magnet
Tuổi thọ cơ học, tối thiểu	10,000,000 Operations
Gắn	central with threated flange M12 x 1
Tightening torque of nuts, maximum	0.9 Nm

Dữ liệu cơ học – Switching distances according EN IEC 60947-5-3

Switching distance S_n	5 mm … 55 mm BP 10S = 5 mm 2 x BP 10S = 10 mm BP 15S = 6 mm BP 34S = 20 mm BP 20S = 15 mm BP 31S = 15 mm BP 11S = 5 mm 2 x BP 11S = 15 mm BP 12S = 10 mm 2 x BP 12S = 25 mm BP 21S = 30 mm 2 x BP 21S = 20 … 55 mm BP 22S = 25 mm 2 x BP 22S = 15 … 55 mm BE 20 S = 6 mm
Note (Switching distance Sn)	Actuating distance up to 55 mm depending on actuating magnet and version. The specified switching distances are applicable for the actuation of individually mounted components without ferromagnetic influence. A change of the distance, either positive or negative, is possible due to ferromagnetic influences. The mutual interference between multiple actuating magnets must be observed.
Repeat accuracy R	0.3 mm

Dữ liệu cơ học – Connection technique

Dữ liệu cơ học – Dimensions

Điều kiện môi trường xung quanh

Dữ liệu điện

Dữ liệu điện – Digital Output

Design of control elements	Reed contacts

Scope of delivery

Scope of delivery	Actuator must be ordered separately.

Accessory

Recommendation (actuator)	BP 10 S 2x BP 10 S BP 15 S BP 34 S BP 20 S BP 31 S BP 11 S 2x BP 11 S BP 12 S 2x BP 12S BP 21 S 2x BP 21 S BP 22 S 2x BP 22 S BE 20 S
Recommendation (actuator, lift switchgear)	BP 10 2 x BP 10 BP 15 BP 34

Note

Note (General)	The opening and closing functions depend on the direction of actuation, the actuating magnets and the polarity of the actuating magnets. When the switches and actuators come together, the colours must coincide: Red (S) to red (S) and green (N) to green (N). This does not apply to the bistable contact. The switch is to be mounted on iron with a non-magnetic layer of at least 20 mm.