Cảm biến từ BN 12-01Z/V

Schmersal 101186835

Thông số kỹ thuật cảm biến công tắc từ tính Schmersal BN 12-01Z/V

đại lý schmersal | đại lý BN 12-01Z/V

nhà phân phối schmersal | nhà phân phối BN 12-01Z/V

Dữ liệu đặt hàng

Dữ liệu chung

Dữ liệu chung – Features

Dữ liệu cơ học

Actuating panels	front side
Yếu tố kích hoạt	Magnet
Tuổi thọ cơ học, tối thiểu	10,000,000 Operations
Tốc độ khởi động, tối đa	18 m/s
Gắn	central with threated flange M12 x 1

Dữ liệu cơ học – Switching distances according EN IEC 60947-5-3

Switching distance S_n	5 mm … 55 mm BP 10S = 5 mm 2 x BP 10S = 10 mm BP 15S = 6 mm BP 34S = 20 mm BP 20S = 15 mm BP 31S = 15 mm BP 11S = 5 mm 2 x BP 11S = 15 mm BP 12S = 10 mm 2 x BP 12S = 25 mm BP 21S = 30 mm 2 x BP 21S = 20 … 55 mm BP 22S = 25 mm 2 x BP 22S = 15 … 55 mm BE 20 S = 6 mm
Note (Switching distance Sn)	Actuating distance up to 55 mm depending on actuating magnet and version. The specified switching distances are applicable for the actuation of individually mounted components without ferromagnetic influence. A change of the distance, either positive or negative, is possible due to ferromagnetic influences. The mutual interference between multiple actuating magnets must be observed.
Repeat accuracy R	0.3 mm

Dữ liệu cơ học – Connection technique

Dữ liệu cơ học – Dimensions

Diameter of sensor	10.7 mm
Chiều dài của cảm biến	71 mm

Điều kiện môi trường xung quanh

Dữ liệu điện

Dữ liệu điện – Digital Output

Design of control elements	Reed contacts

Scope of delivery

Scope of delivery	Actuator must be ordered separately.

Accessory

Recommendation (actuator)	BP 10 S 2x BP 10 S BP 15 S BP 34 S BP 20 S BP 31 S BP 11 S 2x BP 11 S BP 12 S 2x BP 12S BP 21 S 2x BP 21 S BP 22 S 2x BP 22 S BE 20 S
Recommendation (actuator, lift switchgear)	BP 10 2 x BP 10 BP 15 BP 34

Note

Note (General)	The opening and closing functions depend on the direction of actuation, the actuating magnets and the polarity of the actuating magnets. When the switches and actuators come together, the colours must coincide: Red (S) to red (S) and green (N) to green (N). This does not apply to the bistable contact. The switch is to be mounted on iron with a non-magnetic layer of at least 20 mm.